Filter
Top Products
140
VQT1Y00
If the SD card is inserted
in another device, it is not
recognized.
≥ Check that the device is compatible with the capacity or
type of SD card (SD Memory Card/SDHC Memory Card)
that you inserted. Refer to the operating instructions of the
device for details.
Color or brightness of the
image changes, or you
may see horizontal bars
in the image.
≥ Color or brightness of the image may change, or you may
see horizontal bars in the image when the object is
recorded under fluorescent light, mercury light or sodium
light, etc., but this is not a malfunction. In this case, record
in Auto Mode or set the shutter speed to 1/60 in areas
where the power supply frequency is 60 Hz, or 1/100 in
areas of 50 Hz.
Object seems to be
warped.
≥ Object seems to be warped slightly when the object moves
across the image very fast, but this is because the unit is
using MOS for the image sensor. This is not a malfunction.
White round spots like
soap bubbles appear on
the recorded picture.
≥ If you take a picture with the
flash in a dark place or indoors,
white round spots may appear
on the picture caused by the
flash reflecting of particles of
dust in the air. This is not a
malfunction.
A characteristic of this is that the number of round spots
and their position differ in every picture.
“ERROR OCCURRED.
PLEASE TURN UNIT OFF,
THEN TURN ON AGAIN.”
is displayed.
≥ The unit has automatically detected an error. Restart the
unit by turning the power off and on.
≥ The power will be turned off in about 1 minute if the power
is not turned off and on.
≥ Repair is needed if it is repeatedly displayed even if it is
restarted. Detach the power connected, contact consumer
support. (l 157, 158) Do not attempt to repair the unit by
yourself.
Problem Check points
HDCSD20&SD25&HS20P-VQT1Y00_eng.book 140 ページ ２００８年１２月２２日 月曜日 午後８時１６分