Filter
Top Products
42
VQT3J95
This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopened.
≥ When in Quick start standby mode about 60% of the power used in Recording pause
mode is being consumed, so the recording time will be reduced.
≥
Quick start will not work if there is no SD card inserted.
≥ /
Quick start will not work if the [SD CARD] is selected in the [MEDIA SELECT], even if there
is no SD card inserted.
≥ Change the mode to .
1Set [QUICK START] to [ON].
2 Close the LCD monitor while the mode is set to
.
The status indicator A flashes green and the unit goes
into Quick start standby mode.
3 Open the LCD monitor.
The status indicator A lights red and the unit
is put into recording pause.
≥ Quick Start Standby Mode is canceled if
jabout 5 minutes have elapsed
jmode is set to
≥ It may take some time for Automatic white balance to adjust.
≥ In the Quick Start Mode, the zoom magnification becomes 1k.
≥ If [ECONOMY] (l 41) is set to [5 MINUTES] and the unit automatically goes into Quick
Start Standby Mode, close the LCD monitor and then open it again.
≥ Turn the unit off using the power button.
Starting and stopping of recording and unit on/off can be confirmed with this sound.
(Volume low)/ (Volume high)
2 Beeps for 4 times
When an error occurs. Check the sentence displayed on the screen. (l 101)
[QUICK START]
[OFF]/[ON]
[ALERT SOUND]
[OFF]/ /
HDC-SD40&TM40P_PC_VQT3J95_mst.book 42 ページ ２０１１年１月２０日 木曜日 午前１１時４９分