Filter
Top Products
127
VQT2H52
Problem Check points
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
≥ Turn on the power again. If normal conditions are not
restored yet, remove the battery or AC adaptor, wait about
1 minute and then reconnect the battery or AC adaptor.
Then about 1 minute later, turn on the power again.
(Conducting the above operation while the media is being
accessed may damage the data on the media.)
≥ If normal operation is still not restored, detach the power
connected, and contact consumer support. (l 145)
Recording does not start
although power is
supplied to this unit and
the SD card is correctly
inserted.
≥ A message is displayed and you cannot record when the
built-in memory does not operate normally, or when the SD
card cover cannot be closed due to failure of the SD card
cover. In this case, press the recording start/stop button to
display the media change message, allowing you to change
the recording media.
Item other than the
touched one is selected.
≥ Calibrate the touch screen. (l 37)
The remaining time
indication or the elapsed
time indication is not
shown.
≥ If you set [SETUP] > [DISPLAY] > [OFF], indications
other than warnings and date etc. are not displayed. (l 31)
The unit arbitrarily stops
recording.
≥ Use an SD card that can be used for motion picture
recording. (l 24)
When the unit stops while a usable SD card for recording
motion pictures (l 24) is used, the data writing rate has
deteriorated. We recommend formatting the SD card being
used. (l 89)
≥ If [AGS] is [ON], record in the normal horizontal position or
set [AGS] to [OFF]. (l 58)
≥ Repeated recording and deletion of motion pictures may
reduce the usable time for recording on a media you use. In
that case, format the media.
AF tracking does not
work when the object is
touched.
≥ Touch the part of the object that has specific color such as
the part that is different from the surrounding. (l 51)
Auto focus function does
not work.
≥ Set the Intelligent auto mode to on or off.
≥ If you are trying to record a scene which is hard to bring into
focus in Auto Focus mode, use the Manual Focus mode to
adjust the focus. (l 40, 69)
HDCSD10_TM10_TM15P-VQT2H52_eng.book 127 ページ ２００９年７月６日 月曜日 午後１時４６分