Filter
Top Products
41
VQT2H52
This unit will resume recording pause mode about
0.6 seconds after the LCD monitor is reopened.
≥
When in Quick Start Standby mode about 70%
of the power used in Recording Pause mode
is being consumed, so the recording time will
be reduced.
≥ Start time will not shorten if there is no SD card
inserted.
/
Start time will be shorten if the [Built-in
Memory] is selected in the [MEDIA SELECT],
even if there is no SD card inserted.
¬Change the mode to .
1 Select the menu. (l 29)
2 Close the LCD monitor while the
mode is set to .
The status indicator A flashes green and the unit
goes into quick start standby mode.
3 Open the LCD monitor.
The status indicator A lights red and the unit is
put into recording pause.
≥ Quick Start Standby Mode is canceled if
jabout 5 minutes have elapsed
jmode is set to with the LCD monitor
closed.
≥
Time for Quick Start will be more than 0.6
seconds slower when the digital cinema is used.
≥ It may take some time for Automatic White
Balance to adjust.
≥ In the Quick start mode, the zoom
magnification becomes 1k.
≥ If [ECONOMY] (l 31) is set to [5 MINUTES]
and the unit automatically goes into Quick Start
Standby Mode, close the LCD monitor and
then open it again.
≥ Turn the unit off using the power button.
When the power is turned on with the mode set
to , the unit will enter the recording pause
mode after about 1.9 seconds.
¬Change the mode to .
Select the menu. (l 29)
≥ This function’s default setting is [ON].
≥ In the Quick power on mode, the zoom
magnification becomes 1k.
Quick start
[SETUP] # [QUICK START] # [ON]
Quick power on
[SETUP] # [QUICK POWER ON] # [ON]
HDCSD10_TM10_TM15P-VQT2H52_eng.book 41 ページ ２００９年７月６日 月曜日 午後１時４６分