Filter
Top Products
12
VQT2M51
Quick Guide
∫ Inserting the battery
Install the battery by inserting it in the
direction shown in the figure.
A Insert the battery until it clicks and locks.
∫ Charging the battery
A DC input terminal
1 Connect the AC adaptor to the DC input
terminal.
2 Connect the AC cable to the AC
adaptor, then the AC outlet.
≥ The status indicator will flash red at an
interval of 2 seconds, indicating that
charging has begun.
∫ Inserting/removing an SD card
1) Open the LCD monitor.
2) Open the SD card cover and insert
(remove) the SD card into (from) the
card slot B.
≥ Face the label side C in the direction
shown in the illustration and press it
straight in as far as it will go.
≥ Press the center of the SD card and then
pull it straight out.
3) Securely close the SD card cover.
≥ Securely close it until it clicks.
∫ Turning the unit on/off
Turning the power on and off with the
power button
Press the power button to turn on the power.
A The status indicator lights on.
≥ To turn off the power, hold down the power
button until the status indicator goes off.
Turning the power on and off with the
LCD monitor
Power is turned on when the LCD monitor is
opened, and power is turned off when it is
closed.
∫ To turn on the power
A The status indicator lights on.
∫ To turn off the power
B The status indicator goes off.
Access lamp [ACCESS] A
≥ When this unit is accessing the SD
card or built-in memory, the access
lamp lights up.
HDCSD60_TM60_HS60-P_PC-VQT2M51_eng.book 12 ページ ２０１０年１月１８日 月曜日 午前１１時３３分