Filter
Top Products
6
Pull out the lid by holding on the grip near the lock
4.5 Mounting the camera in the housing:
Remove the lens cap and wrist strap. Check the white dots on the control “Flash on”, “On/OFF)”
and “Aspect Ratio” are facing the Housing Cover Lid.
Slide the camera into the body along the rubber packing. Make sure the camera body reach the
limit and test the function of the On/Off button on the body of the housing.
Check the bulkhead cable is not jammed under any button or over the o-ring
Slide the hot shoe plug into the hot shoe
Replace the lid and make sure the lever is perpendicular to the side wall of the housing. Lock the
lid by press down the lever and turn until the lever is parallel to the side wall of the housing.
After replacing and locking the lid, make a final visual inspection of the main O-ring for