Filter
Top Products
Before using
17
LSQT1284
Quick Start
When Quick Start is ON the battery power is still
being consumed, even when the LCD Monitor
and the Viewfinder are closed.
The Camcorder will resume recording/pause
mode about 1.7 seconds after the LCD Monitor or
the Viewfinder is reopened.
≥Please note in Quick Start Mode approximately
half the pause recording power is being
consumed. Using Quick Start Mode will reduce
the battery recording/playback time.
≥This is only activated in the following cases.
≥While using the battery
A tape is inserted, while the Tape Recording
Mode is set.
≥While using the AC adaptor
Quick Start can be used even if a tape is not
inserted.
≥Set to Tape Recording Mode.
1 Set [SETUP] >> [QUICK START] >> [ON].
(
-20-)
2 Close the LCD monitor and retract the
viewfinder while the mode dial is set to
Tape Recording Mode.
≥The Status indicator lights green and the unit
goes into quick start standby mode.
≥The Camcorder will not go into quick start
standby mode unless the LCD monitor is
closed and the viewfinder is retracted.
3 Open the LCD monitor or extend the
Viewfinder.
≥The status indicator lights red and the
Camcorder is put into recording pause
approx. 1.7 seconds after it is turned on.
ª
To cancel Quick Start
1
Set [SETUP] >> [QUICK START] >> [OFF].
(
-20-)
≥The status indicator goes off and the power
turns off if the mode dial is set to OFF while the
unit is in quick start standby mode.
≥If the standby continues for approx. 30 minutes,
then the Status indicator will go off and the
Camcorder will be completely turned off.
≥In the following cases, quick start is canceled
and the power turns off.
≥When the Mode dial is moved.
≥When the battery or AC adaptor is removed.
≥When the tape is removed while using the
battery in Tape Recording Mode.
≥When the Camcorder is quick-started with the
white balance on automatic, it may take some
time until the white balance is adjusted if the
scene being recorded has a light source
different from the scene last recorded. (When
the MagicPix function is used, however, the
white balance of the scene last recorded is
retained.)
≥If the power is turned on in quick start standby
mode, the zoom magnification becomes 2t and
the picture size may differ from what it was
before quick start standby mode.
≥If [POWER SAVE] (
-24-) is set to [5 MINUTES]
and the unit automatically goes into quick start
standby mode, close the LCD monitor and
retract the viewfinder and then open the LCD
monitor or extend the viewfinder again.
PV-GS90P_LSQT1284_Eng.book 17 ページ ２００７年１１月２８日 水曜日 午前９時２０分