Filter
Top Products
Setting up
8
VQT0U14
A: USB connection cable
B: AC Adaptor (optional)
C: This message appears during data
transfer.
Preparations on the digital camera side
When you connect the digital camera to
the PC, use batteries with sufficient
battery power or the AC adaptor. If the
remaining battery power is exhausted
during communication, the recorded data
may be damaged.
• If you use the AC adapter, connect it.
• Turn on the digital camera.
• Set [USB MODE] in the [SETUP] menu
to [PC].
1. Connect the digital camera
to the PC via the supplied
USB connection cable.
• When the connection is established
correctly, Simple Viewer automatically
opens the screen to begin file transfer.
(P9)
If Windows 98 is used, refer to P23.
• When the following screen appears, click
[Cancel] to close it.
• If Simple Viewer does not start
automatically, refer to P27.
• Do not operate the digital camera or
disconnect the USB connection cable
while transferring data from the digital
camera. The software may not function
correctly and damage the data being
transferred.
• The shape of the terminal varies
depending on the digital camera used.
For details, refer to the operating
instructions for the digital camera.
Connecting the Digital Camera to PC
• When Windows 98/98SE is used, install the USB driver (P6) before connection.
• If the PC has a built-in SD memory card slot, insert a Card into the slot and you can
transfer pictures to the PC by use of Simple Viewer.
DIGITAL
AV OUT
DC IN
ACCESS
VQT0U14ENG.book 8 ページ ２００５年６月３０日 木曜日 午前１１時３１分