Filter
Top Products
5
l Clean the O-ring recess (the square groove where the O-ring sits) with a cotton bud.
l Inspect the O-ring all the way round its surface for damage such as cuts tears or
contamination. This should be done visually and also by feeling the surface texture between
finger and thumb.
l IF THE O-RING IS DAMAGED OR SUSPECTED
OF BEING DAMAGED, DISCARD IT
IMMEDIATELY.
A spare O-ring is supplied with your housing, or a
replacement O-ring can be ordered from 10BAR. If
the O-ring is contaminated or suspected of being
contaminated, clean it with a cotton cloth that is free
of all chemicals or contamination. After cleaning
inspect the O-ring again.
Once the O-ring has been inspected and verified fit for use, apply a small amount of silicone
grease to the O-ring. The silicone grease must be evenly distributed round the O-ring.
Replace the O-ring into the groove; run a finger round the O-ring, to make sure it is snugly seated
in the groove.
4.4 Key Hole Lock
The Key -hole Lock is simple and easy to use and adding security.
Turn the levers of the lock perpendicular to the wall of the housing until the lock is released on
both sides.
Pull out the lid by holding on the grip near the lock