Selecting the Data Entry Mode
There are two ways to enter data on the 9401/9402 with a
scanner.
• In Auto Enter mode, the printer reads a successful scan,
then immediately goes to the next prompt.
• When not in Auto Enter mode, the operator must press
to proceed to the next prompt after scanning.
1. From the Main Menu, press or until you see
MAIN MENU
< Setup >
2. Press . You’ll see
SETUP
Supply >
3. Press until you see
SETUP
< Port Settings >
4. Press . You’ll see
PORT SETTINGS
User Comm >
5. Press until you see
PORT SETTINGS
< Scanner
9401/9402 Scanner Operator’s Handbook
4