Filter
Top Products
[ 2 ] Pelco Manual C1971M-D (1/03)
DESCRIPTION
The lens packs for Pelco’s ICS090, ICS100, ICS150, ICS200, and ICS300 Series Camclosure
®
integrated
camera systems contain an interchangeable lens mount(s) and lens(es). All lenses are fixed focal length,
ranging from 2.9 mm to 12 mm.
NOTE: Do not replace varifocal lenses. Only Camclosure integrated camera systems with fixed focal
length lenses have an interchangeable lens mount and lens. If your unit has a varifocal lens, do not
remove the mount or lens.
Models
13FF3D One 2.9 mm lens and mount
13FF3.6D One 3.6 mm lens and mount
13FF6D One 6 mm lens and mount
13FF8D One 8 mm lens and mount
13FF12D One 12 mm lens and mount
13FF3D-4PAK Package of four 2.9 mm lenses and mounts
13FF3.6D-4PAK Package of four 3.6 mm lenses and mounts
13FF6D-4PAK Package of four 6 mm lenses and mounts
13FF8D-4PAK Package of four 8 mm lenses and mounts
13FF12D-4PAK Package of four 12 mm lenses and mounts
13FFD-V5PAK Variety package of five lenses, one each 2.9 mm, 3.6 mm, 6 mm, 8 mm, 12 mm, and
mounts
INSTALLATION
Remove the camera module from the base of the enclosure. After replacing and adjusting the lens,
reinstall the camera module.
Monochrome Camera
The lens mount installed on the monochrome camera is fixed; DO NOT REMOVE. To replace the lens do
the following:
1. Remove the lens from the camera mount.
a. Loosen the set screw located on the lens
mount. Back out the set screw until it clears
the threads of the lens. Do not completely
remove set screw.
b. Unscrew the lens by turning it counterclockwise.
2. Mount the replacement lens by carefully threading
it clockwise onto the lens mount.
3. Remove the dust cover from the lens.
4. Lens Adjustment – Turn the lens clockwise/
counterclockwise until the picture on the
monitor is in focus. Carefully tighten the set
screw. Do not over-tighten.
LOOSEN SET
SCREW. DO
NOT REMOVE.
TURN COUNTERCLOCKWISE
REMOVE LENS
DO NOT OVER
-
TIGHTEN SET
SCREW
TURN CLOCKWISE
MOUNT AND
ADJUST LENS