Filter
Top Products
Creating Custom Wiegand Card Formats
6
For Intelli-M Supervisor Plus And Intelli-M Web Interface Users
Standard 35-bit Corporate 1K (for eIDC Only)
The standard 35-bit Corporate 1k card format (shown above) that is listed as a default format
within Supervisor Plus can be customized to work with an IDC controller. Customizing that will
allow the format to work (with limitations) for both eIDC and IDC controllers within Supervisor
Plus is as follows:
Non-standard 35-bit Corporate 1K (for IDC and possibly eIDC)
With the non-standard 35-bit Corporate 1K format for IDC and eIDC controllers, the card site
code is limited to between 0 to 8191. The card number is limited to between 0 to 65535. This is
fine for an IDC controller, since the IDC is limited to card numbers no greater than 65535. (Refer
to Table D-1 above.) This format becomes a problem though for cards used on an eIDC or IDC
controller with a card number greater than 65535. Currently, cards in this format with a card
number greater than 65535 are not read properly by the eIDC or IDC; that is, the card number
printed on the card will not match what is read by either controller within Supervisor Plus.
Important: Consider using the non-standard 35-bit Corporate 1K format only with IDC
controllers.
Instructions for creating custom Wiegand formats are provided in the section below.