Filter
Top Products
Worldwide Headquarters • 3500 Pelco Way • Clovis, California 93612 USA •
www.pelco.com
USA & Canada • Tel: 800/289-9100 • Fax: 800/289-9150
International • Tel: 1-559/292-1981 • Fax: 1-559/348-1120
Routine Servicing
Never touch the surface of the lens.
Remove dust from the lens using a soft brush or clean compressed air. Avoid touching the lens surface during handling.
To remove fingerprints or oil stains from the lens surface, use lens cleaning paper or a clean cotton cloth with a little cleaning liquid. Then, wipe off the
stains using a light circular motion, starting from the center of the lens surface. Wipe the lens body with a silicon cloth. Do not use any organic solvents
such as thinner or benzene.
Lens and Connector Wiring Diagrams
Specifications
Technical specifications are available from Pelco by any of the following methods:
• Product Specification Book
• Pelco’s B.O.S.S.
®
Software
•Web Site, Pelco Online at www.pelco.com
(Design and product specifications subject to change without notice.)
REVISION HISTORY
Manual # Date Comments
C748M-B 11/05 Added information on VDIR lenses. Reformatted manual.
Pelco and the Pelco logo are registered trademarks of Pelco. ©Copyright 2005, Pelco. All rights reserved.
RED
BLACK
YELLOW
G
IRIS
4 -CONDUCTOR
CABLE
4-PIN SQUARE CONNECTOR
3
4
2
TO CAMERA AUTO-IRIS SOCKET, DC DRIVE
AUTO-IRIS PLUG PIN-OUT
(REAR OF PLUG, SOLDER LUGS)
4 2
3 1
1
DRIVE ( + )
DRIVE ( – )
CONTROL ( – )
CONTROL ( + )
GREEN
RED
BLACK
WHITE
G
IRIS
4-PIN SQUARE CONNECTOR
3
4
TO CAMERA AUTO-IRIS SOCKET, VIDEO DRIVE
AUTO-IRIS PLUG PIN-OUT
(REAR OF PLUG, SOLDER LUGS)
4 2
3 1
1
DC+ (8-16)
GROUND
REMOTE
VIDEO
GREEN
AUTO-
IRIS
CIRCUIT
4-CONDUCTOR CABLE
Pelco VD Type Lenses
Pelco VV Type Lenses
This equipment contains electrical or electronic components that must be recycled properly to comply with Directive 2002/96/EC of the European Union
regarding the disposal of waste electrical and electronic equipment (WEEE). Contact your local dealer for procedures for recycling this equipment.