Filter
Top Products
[ 18 ] Pelco Manual C2933M (10/05)
SPECIFICATIONS
GENERAL
Imaging Device: 1/3-inch interline transfer CCD
Picture Elements
CC3610UH and CC3710UH: NTSC 768 (H) x 494 (V); PAL 752 (H) x 582 (V)
Sensing Area: 6 mm diagonal
Scanning System
NTSC: 525 lines, 2:1 interlace
PAL: 625 lines, 2:1 interlace
Synchronization System: AC line lock/internal
Horizontal Resolution
CC3610UH and CC3710UH: 540 TV lines
Iris Control: Selectable on/off
Electronic Shutter Range
NTSC: 1/60-1/100,000 second
PAL: 1/50-1/100,000 second
Auto Iris Lens Type: DC/video drive (automatic sensing)
Minimum Illumination
CC3610UH models: 0.4 lux at F1.2, 40 IRE, AGC on
CC3710UH models: 0.7 lux at F1.2, 40 IRE, AGC on
Signal-to-Noise Ratio: >50 dB
Vertical Phase: Adjustable ±180°
Automatic Gain Control: On/off switchable
Electronic Shutter Control: On/off switchable
Backlight Compensation: On/off switchable
Flickerless Mode: On/off switchable
Internal Sync: On/off switchable
Auto White Balance: On/off switchable
Signal Processing: Digital Signal Processing (DSP)
Video Output: 1 Vp-p, 75 ohms
Auto White Balance Range: 2,500°K to 9,500°K
Gamma Correction: 0.45
ELECTRICAL
Power Requirements
Low Voltage Models: 24-28 VAC ± 10% or 12-36 VDC ± 10%
High Voltage Models: 110-240 VAC ± 10%
Power Consumption: 5 watts
Power Connector
Low Voltage Models: 2-pin terminal strip, RJ45-10 connector
High Voltage Models: Integral power cable
Video Connector: Composite via BNC, composite and twisted-pair via RJ45-10
Service Connector: 2.5 mm jack for optional ICS090-SC service/monitor cable
(compatible with any standard monitor BNC connector)
Lens Jack: 4-pin connector (miniature square)
MECHANICAL
Lens Mount: C/CS mount (adjustable)
Camera Mount: 1/4 –inch UNC-20 screw, top or bottom of camera housing