Filter
Top Products
4 Pelco Manual C1961M-B (3/01)
DESCRIPTION
The CCC1300H-2, CCC1300H-2X, and MCC1300H-2 Digital Cameras are high
resolution, compact video cameras that feature a 1/3-inch CCD imager. The camera’s
high resolution and high-density image sensor ensure a sharp and clear picture over a
wide range of conditions.
MODELS
CCC1300H-2 1/3-inch, high resolution color CCD camera, 24VAC, 60Hz, NTSC
CCC1300H-2X 1/3-inch, high resolution color CCD camera, 24VAC, 50Hz, PAL
MCC1300H-2 1/3-inch, high resolution monochrome CCD camera, 24VAC, 60Hz, EIA
LOCATION AND FUNCTION OF PARTS
Refer to Figure 1.
1 Lens Mount
The camera has a standard CS lens mount, but can use a C-mount lens when a
C/CS-mount adapter is installed between the lens and camera.
2 Back Focus Lock Screw
Loosen to adjust the back focus to match the lens attached to the CS mount.
Refer to the section on
Back Focus Adjustment
in this manual.
3 Camera Mounts
Top or bottom mounting. Maximum thread length is 3/16-inch. Attach the camera
mount adaptor to extend thread depth to a standard 1/4-inch.
4 Level Adjuster
Controls the video output level when using a DC-controlled auto iris lens.
5 Lens Connector
Four-pin auto iris drive connector.
6 Video Output Connector
This coaxial connector (BNC-type) outputs the video signals.
7 Iris Mode Selector Switch
Switch to VIDEO when an auto iris lens is controlled by a video signal. Switch to
DC when using a DC voltage drive lens.
8 LL ADJ Switches
Use switches to adjust the vertical phase up or down to eliminate vertical roll
when multiple cameras are connected to a switching device. Each camera’s
output is synchronized to the frequency of the power supply.
9 AGC - Automatic Gain Control
Automatically adjusts the image to compensate for changes in light levels.
The AGC function switch can be turned ON/OFF by moving the AGC switch right
or left. AGC is factory set to ON.