Filter
Top Products
C2924M-A (5/05) 33
MASKING
Masking lets you block out certain areas of a camera scene. Select this option to configure one to
eight masks in the camera image.
NOTE: When you enable masking, electronic zoom is disabled. If electronic zoom is active, masking
is disabled.
Mask
Use this option to enable or disable masking. The default is OFF.
Mask Edit
Use this option to configure one or more masks. There is no default mask.
To edit a mask:
1. Change the MASK setting on the MASKING menu to ON.
2. Select the MASK EDIT menu. The MASK SETTING menu appears.
3. Use the pointer to configure the mask area.
a. Press the button up, down, left, or right to move the cursor to the upper left corner of the
mask.
b. Press the center of the button to mark the upper left corner.
c. Press the button up, down, left, or right to move the cursor to the lower right corner of
the mask.
NOTE: If you move the cursor either left or above the start point, the mask edit is cancelled.
d. Press the center of the button to mark the lower right corner. The mask area is blacked out. The MASKING menu appears with the
new mask.
4. Repeat step 3 for each additional mask.
If you add a ninth mask, the camera erases the first mask. You cannot configure more than eight masks.
Mask Erase
Select this option to erase one or more masks. The camera erases masks from the last created to the first created.
To erase a mask, select MASK ERASE. The mask that was last created disappears. Repeat to erase additional masks.
TITLE
Select this option to configure the camera title.
Title
Use this option to enable or disable the title display. The default is OFF.
Title Edit
Use this option to enter or edit the camera title, up to 16 characters. The default is blank.
To enter a camera title:
1. Change the TITLE setting on the TITLE menu to ON.
2. Select the EDIT TITLE menu. The EDIT TITLE menu appears.
3. Press the button up, down, left, or right to move the cursor to the desired character.
The space character is located below the letter n.
4. Press the center of the button to select the character. The selected character appears in the
blank area at the bottom of the screen.
MASKING
MASK > OFF
MASK EDIT >
MASK ERASE
BACK EXIT
MASK SETTING
TITLE
TITLE > OFF
EDIT TITLE >
BACK EXIT
EDIT TITLE
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
abcdefghijklm
nopqrstuvwxyz
0123456789-/
BACK BS
_________________