Filter
Top Products
C202M-C (1/08) 3
INSTALLATION
To attach the mount, perform the following steps:
1. Determine the location where the mount is to be installed.
2. Using the mount as a template, mark and drill holes in the mounting surface.
3. Pull the wiring from the cable hole in either the mounting plate or the side of the mount near the
mounting plate. Then pull the wiring through the mount arm.
4. Attach the mount securely with four 1/4-20 fasteners (not provided) of appropriate length. When
installing the mount outdoors, seal the mounting holes with an appropriate sealant. Apply the
sealant around the holes located between the mount and the mounting surface.
5. Attach the enclosure or camera securely with the two 1/4-20 x 0.625-inch (1.588 cm) hex bolts
provided.
6. Loosen the bolts on the swivel head and position as desired. Tighten bolts and lock into place.
7. Make all necessary electrical connections to the enclosure and camera (refer to the manuals
provided with the enclosure and camera.)
SERVICE MANUAL
If you need replacement parts, obtain a service manual in one of the following ways:
• Go to Pelco’s Web site at ftp://www.pelco.com and find service manual C202SM-A.
• Contact Pelco’s Literature Department and request service manual C202SM-A.
WARNING: Make certain that the mounting surface is capable of supporting four times the full
load of the mount, enclosure, and camera.