Filter
Top Products
10 C493M-G (11/97)
HEATER/BLOWER KIT INSTALLATION
To install the HB1500/HB1524 heater/blower kit, perform the following steps:
1. Remove the cover (Figure 5, item 4).
2. Attach the heater pads to each side of the mounting frame, below the tilt table assembly.
3. Attach the PC board/fan assembly to the mounting frame, to the left or right of the tilt table assembly (see Figure 2).
4. The blower is factory wired to the PCB assembly.
5. Close and lock the cover.
Figure 2.
Heather/Blower Installation
Connect the heaters to the PCB assembly as shown in Figure 3.
Figure 3.
Heater/Blower Wiring Diagram