Filter
Top Products
[ 6 ] Pelco Manual C1982M-A (12/00)
CAMERA LAYOUT
Figure 1. Camera Layout
NOTE: The cosmetic trim ring conceals the LED light for more discreet surveillance operations.
The trim ring also hides the power connectors and protects the DIP switches.
INSTALLATION
Lens Mounting
The MC3500 and MC3600 Series cameras can use fixed iris, manual iris, auto iris, or direct drive
lenses. Cameras are factory-set for CS-mount lenses, but easily adjusted for C-mount lenses.
1. C-Mount Lens Only - Loosen the two back focus locking screws. Rotate the back focus
adjustment ring fully counterclockwise before installing the C-mount lens (refer to the section on
Back
Focus Adjustment
).
2. Remove the cosmetic trim ring from the back of the camera (refer to Figure 1). Set the lens mode
selector switch on the side of the camera to AI (auto iris video drive lens)or DD (auto iris DC drive
lens). Refer to the
Switch Settings
section. Switch setting is determined by the type of lens used.
3. Screw the lens onto the lens mount. Be careful to prevent dust from entering the space between the
lens and the CCD element. If necessary, use clean, compressed air to remove any foreign matter.
4. Thread the lens cable through the cosmetic trim ring.
5. Connect the direct drive (DD) or auto iris (AI) lens to the 4-pin iris drive connector located on the
side of the camera. Refer to Figure 2 for the pin connections for the iris drive connector.
BACK FOCUS
ADJUSTMENT
RING
BNC VIDEO CONNECTOR
LENS CONNECTOR
DIP SWITCHES
LED
MOUNT ADAPTER
PHASE ADJUSTMENT
LEVEL ADJUSTMENT
POWER SUPPLY
BACK FOCUS
ADJUSTMENT
LOCKING
SCREW
COSMETIC TRIM
RING