2
• Do not look at the sun or other strong light sources through the lens. Doing so may
lead to a loss of eyesight or cause vision to be impaired.
• If any irregularities occur during use, such as smoke or a strange odor, stop use
immediately, remove the battery or the AC adapter, and contact your nearest
PENTAX Service Center. Continued use can cause a fire or electrical shock.
Caution
• Do not place your finger over the flash when discharging the flash. You may burn
yourself.
• Do not cover the flash with clothing when discharging the flash. Discoloration may
occur.
• Some portions of the camera heat up during use. There is a risk of low temperature
burns when holding such portions for long periods.
• Should the monitor be damaged, be careful of glass fragments. Also, be careful not
to allow the liquid crystal to get on your skin or in your eyes or mouth.
• Depending on your individual factors or physical condition, the use of the camera may
cause itching, rashes or blisters. In case of any abnormality, stop using the camera
and get medical attention immediately.
Warning
• Always use the battery charger and AC adapter exclusively developed for this
camera, with the specified power and voltage. Using a battery charger or AC adapter
not exclusive to this camera, or using the exclusive battery charger or AC adapter with
an unspecified power or voltage can cause a fire, electric shock, or camera
breakdown. The specified voltage is 100 - 240V AC.
• Do not disassemble or modify the product. This can cause a fire or electrical shock.
• If the generation of smoke or strange odor from the product or other abnormality
occurs, immediately discontinue using and consult a PENTAX Service Center.
Continued use can cause a fire or electrical shock.
• If water should happen to get inside the product, consult a PENTAX Service Center.
Continued use can cause a fire or electrical shock.
• If you see a lightning flash or hear thunder during use of the battery charger or AC
adapter, unplug the power plug and discontinue use. Continued use can cause
damage to the product, fire or electrical shock.
• Wipe off the power plug if it should become covered with dust. Accumulated dust may
cause a fire.
• To reduce the risk of hazards, use only CSA/UL certified power supply cord set, cord
is Type SPT-2 or heavier, minimum NO.18 AWG copper, one end with a molded-on
male attachment plug cap (with a specified NEMA configuration), and the other is
provided with a molded-on female connector body (with a specified IEC nonindustrial
type configuration) or the equivalent.
About the Battery Charger and AC Adapter