Filter
Top Products
*
21 Even the Lens warning is blinking with Z-1, Z-5 and Z10, built-in flash can be used if the
focus distance is more than 0.7m which is within distance of Minimum Auto flash distance.
*
22 Vignetting will occur at focus distance less than 1m.
Even the Lens waning is blinking with Z-1, Z-5 and Z10, built-in flash can be used freely at
focus distance more than 1m.
*
23 Vignetting may occur at focal lengths 18mm and the shooting distance within 1m.
*
24 Vignetting may occur at focal lengths between 28-35mm and the shooting distance less
than 1m.
*
25 Vignetting may occur at focal lengths between 80-90mm.
*
26 Vignetting may occur at focal lengths less than 20mm.
STATEMENT OF FCC COMPLIANCE
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions : (1) This device may not cause harm-
ful interference, and (2) this device must accept
any interference received, including interference
that may cause undesired operation.
Changes or modifications not approved by the
party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These lim-
its are designed to provide reasonable protection
against harmful interference in a residential
installation, This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures :
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
41