Philips SCE4430 Camera Accessories User Manual


 
5
ENGLISH
6 Technical specifications
Battery type: Lithium polymer
Rated input: 5V DC, max. 500 mA
Rated output: 5.6V DC, max. 350 mA
Battery capacity: 2000 mAh
Recharging time: 4.5 - 6.5 hours
Operating temperature: 0ºC - 45ºC
Size: 60 x 87 x 16 mm (h x w x d)
Weight: 88 g
7 Troubleshooting
Problem
Possible cause
Solution
The power pack does not charge connected device
Voltage of device does not correspond with that of power
pack.
Refer to the user manual that came with the device.
Improper connection between device and power pack.
Check that connection cord is properly inserted into
both device and power pack.
Damaged connection cable or connector tip.
Replace connection cable or connector tip.
Wrong connector tip used.
Check connector tip and replace if necessary.
Non supplied USB connection cable/connector tip used.
Replace with supplied USB connection cable/connector
tip.
Battery power of power pack too low.
Charge power pack.
Problems with electrical circuit of power pack.
Take the power pack to your local distributor.
Short circuit occurred in the power pack and the power pack
protection function switched off the power pack.
Charge power pack.
Problems with electrical circuit of power pack.
Take the power pack to your local distributor.
Power pack runs out of power quickly
Power pack not fully charged before using.
Fully charge power pack before using.
Supplied AC power adapter was not used for charging power
pack.
Only use supplied AC power adapter for charging power
pack.
Power pack cannot be charged
Improper connection between power pack and wall outlet.
Check that power cord is properly inserted into both
wall outlet and AC power adapter.
Check that adapter plug is properly inserted into the
INPUT 5V DC Jack of the power pack.
Problems with the electrical circuit of the power pack.
Take the power pack to your local distributor.
Note:
If you are unable to solve a problem by following the
above hints, try resetting the power pack by pressing
RESET.The RESET button is recessed to prevent
accidental reset of the power pack. Use a paperclip to
gently press the RESET button (see fig. D).
8 Maintenance
Recharge the power pack every three months when it is
not being used for a long period of time.
Use a soft, lint-free cloth to clean the power pack
exterior. Do not use harsh chemicals, cleaning solvents
or strong detergents.
When any problems occur with the power pack or the
accessories, take the adapter and accessories to your
local distributor.
9 Need help?
Online help: www.philips.com/welcome
For interactive help and frequently asked questions.
SCE4430 17-09-2007 13:29 Pagina 5