Pioneer AVIC-F7010BT Camera Accessories User Manual


 
! GPS antenna and its lead
In addition you should lay or route each anten-
na lead as far as possible from other antenna
leads. Do not bind them together, lay or route
them together, or cross them. Such electro-
magnetic noise will increase the potential for
errors in the location display.
Before installing
! Consult with your nearest dealer if installa-
tion requires the drilling of holes or other
modifications of the vehicle.
! Before making a final installation of this
product, temporarily connect the wiring to
confirm that the connections are correct
and the system works properly.
Installing this navigation
system
Installation notes
! Do not install this navigation system in
places where it may become subject to
high temperatures or humidity, such as:
Places close to a heater, vent or air con-
ditioner.
Places exposed to direct sunlight, such
as on top of the dashboard.
Places that may be splashed by rain, for
example close to the door.
! Install this navigation system in an area
strong enough to bear its weight. Choose a
position where this navigation system can
be firmly installed, and install it securely. If
this navigation system is not securely in-
stalled, the current location of the vehicle
cannot be displayed correctly.
! Install the navigation unit horizontally on a
surface within 0 degrees to 30 degrees tol-
erance (within 10 degrees to the left or
right). Improper installation of the unit with
the surface tilted more than these toler-
ances increases the potential for errors in
the location display, and might otherwise
cause reduced display performance.
! The cords must not cover up the area
shown in the figure below. This is neces-
sary to allow the amps and navigation me-
chanism to dissipate heat.
Do not cover thisarea.
! The semiconductor laser will be damaged
if it overheats, so dont install the naviga-
tion unit anywhere hot for instance, near
a heater outlet.
Installation
En
21
English
Section
04