Polaris PMS 419 Film Camera User Manual


 
98
MAINTENANCE
Throttle System
Throttle Body/Idle RPM
Idle RPM is preset by the manufacturer. If the engine idle speed is not
satisfactory, please see your POLARIS dealer for adjustment.
Throttle Freeplay Adjustment
1. Remove both seats. Remove the
rear service panel. See page 31.
2. Locate the throttle cable adjuster
at the throttle body.
3. Slide the cable adjuster boot off
the cable adjuster.
4. Using a 10 mm open-end wrench,
loosen the adjustment jam nut.
5. Using an 8 mm open-end wrench,
move the cable adjuster until 1/16"
to 1/8" (1.5-3 mm) of freeplay is
achieved at the throttle pedal. See page 97. While adjusting, lightly
flip the throttle pedal up and down.
6. Tighten the jam nut.
7. Apply a small amount of grease to the inside of the boot and slide it
over the cable adjuster to its original position.
Boot
Adjuster
Jam Nut