Filter
Top Products
Copyright © 2000-2002: Polycom, Inc.
Polycom, Inc., 4750 Willow Road, Pleasanton, CA 94588
www.polycom.com
Polycom and the Polycom logo are registered trademarks of Polycom, Inc. Concorde, Venue, and WorldCart
are trademarks of PictureTel Corporation.
Velcro is a registered trademark of Velcro USA, Inc.
All other company and product names are the trademarks or registered trademarks of their respective
owners.
The information contained in this document is subject to change without notice. Polycom assumes no
responsibility for technical or editorial errors or omissions that may appear in this document or for the use of
this material. Nor does Polycom make any commitment to update the information contained in this
document. This document contains proprietary information which is protected by copyright. All rights
reserved. No part of this document may be photocopied or reproduced in any form without the prior written
consent of Polycom, Inc.
Edition: 3725-50453-001/A
Note: In this document, the term “monitor” is used to refer to the NTSC or PAL television (TV) broadcast
receiver that is part of the collaboration system. These receivers are governed by different regulations than
computer monitors.
FCC Notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The shielded cables provided with this equipment should be used to ensure compliance with the pertinent
RF emission limits governing this device. Where no cable is provided, shielded interconnection cables
should be used.
Notice to Canadian Users
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
Cet appareil numérique de la classe A respecte toutes les dispositions du règlement sur les interférences
radioélectriques du Canada.
Do you have any suggestions or comments on the documentation yo
u
received? If so, please send them by e-mail to iDesign@pictel.com.