Filter
Top Products
Replacing Receiver Batteries:
1. Turn OFF the receiver power
2. Remove the old batteries (AAA 1.5V or
LR03 Alkaline batteries)
3. Insert two fresh batteries
Using your Remote Flash Trigger:
1. Turn the power of camera and receiver OFF.
2. If your camera has a hot shoe, mount the transmitter to the camera hot
shoe socket. If your camera does not have a hot shoe, connect the PC
cable to the camera PC sync socket and to the transmitter.
3. Mount the flash on to the receiver shoe. If your flash does not have a hot
shoe, connect the flash’s PC cord to the PC sync socket on the receiver.
4. If you are using a PROMASTER flash, set the ADVANCED
FEATURES switch to P. For all other flashes, set the
ADVANCED FEATURES SWITCH to O.
5. Set the channel selector at same position on both the transmitter and the
receiver. To use multiple flash units, be sure to set all receivers to the same
channel.
6. Turn the power of the camera and the receiver(s) ON.
7. Press the test button on transmitter.
8. If the transmitter and the receiver status lights are turning red and your
flash is triggered all of the settings are correct.
For Your Safety
Do not disassemble or modify
Keep Dry
Keep out of reach of children
Do not use in the presence of flammable gas
Do not expose to high temperatures