Filter
Top Products
28
Note
: If your VCR’s original remote does not have a
power key, manually turn on the device, insert a
tape, and repeat Steps 1–6, using
PLAY instead of
POWER. When the device responds, press P. The
red light blinks twice.
Determining the 4-Digit Code
After you set up your remote control using the man-
ual code search, you can find which 4-digit code the
remote control is set to by following these steps.
1. Press the device key (
TV, VCR, or CBL) you want
to get the manufacturer's code from, then hold
down
P until the red light blinks twice.
2. Press
MUTE, MUTE, then VOL +. The red light
blinks twice again.
3. Press
VOL +, then count the number of times the
red light blinks. This is the first digit of the 4-digit
code.
Note:
If the red light does not blink, the digit is a
0.
4. Press
VOL –, then count the number of times the
red light blinks. This is the second digit of the 4-
digit code.
5. Press
CH +, then count the number of times the
red light blinks. This is the third digit of the 4-
digit code.
6. Press
CH –, then count the number of times the
red light blinks. This is the fourth digit of the 4-
digit code.
15-1990.fm Page 28 Tuesday, December 14, 1999 12:45 PM