Wildview Series
www.wildviewcam.com Toll Free 888-304-6125
17
• When you have completed testing the coverage area,
open the front housing and slide the power switch
from Test position to PIR position. Front LCD counter
will show “0000”. The camera will enter count down
mode for 1 minute and the front green indicator will
start blinking, giving you one minute to leave the
coverage area. Then camera will enter PIR detection
mode.
NOTE: Make sure you slide the power switch from TEST
mode to PIR mode before you leave the field. Otherwise
the Camera will not take any pictures.
Switch use: Do not move the switch from TEST directly
to PIR. Doing so will cause the camera to not operate.
Slide the switch to OFF. Wait for the front LCD screen to
turn off then continue to slide the switch to PIR.