Filter
Top Products
- 5 -
WIRING
Note: This range hood must be properly
grounded. The unit should be installed by a
qualified electrician in accordance with all
applicable national and local electrical
codes.
1. Remove the wiring box cover. Remove a
knockout from the wiring box.
2. Feed 6" of power cable through the knock-
out opening and secure cable to the wiring
box with an appropriate connector.
3. Make electrical connections. Connect white
to white, black to black and green to green.
4. Replace wiring box cover and screws. Make
sure that wires are not pinched between
cover and box.
WIRING BOX
COVER
8”
ROUND
STEEL
DUCT
LOWER
DECORATIVE
FLUE
SECTION
CONNECT DUCTWORK
1. Use 8" round steel duct to connect the duct
collar on the hood to the ductwork above.
2. Use duct tape to make all joints secure and
air tight.
3. Slide the lower decorative flue section
downward, until it fits properly around hood.
4. Secure decorative flue to hood with screws
provided.