Filter
Top Products
10
Camera Connection Using RG-59 and 2-Conductor Cables
To connect the camera using RG-59 cable for video and 2-conductor cable for power:
1. Butt splice the camera power leads on the included adapter cable to the 2-conductor cable
at the door station, observing the following polarity:
Polarity Camera Lead 2-Conductor Wire 846C Lead
+ Red Red or White White
– Black Black Black
2. Cut the connector off the end of the output cable of a Russound 846C power supply. Butt
splice the power supply leads to the other end of the 2-conductor cable, observing polarity
as shown above.
Note: Use only insulated butt splices approved for use according to applicable wiring codes.
3. Crimp a BNC connector to the RG-59 cable at the door station. Connect the cable to the
camera video lead of the adapter cable.
4. Plug the adapter cable into the multipin connector on the camera.
5. Connect the other end of the RG-59 to a composite video input of a display or video
distribution system.