Filter
Top Products
ENGLISH
Basic Recording
3535
Adjusting the LCD during PLAY
✤ You can adjust the LCD during playback.
✤ The adjustment method is the same procedure as used in CAMERA mode. (see page 32)
The Speaker works in PLAYER mode only.
■
When you use the LCD screen for playback, you can hear recorded sound from
the built-in Speaker.
- Follow the instructions below to decrease or mute speaker volume in the PLAYER mode.
- Take the following steps to lower the volume or mute the sound while playing a tape
on the camcorder.
1. Set the power switch to PLAYER mode.
2. Press (PLAY/STILL) to play the tape.
3.
When you hear sounds once the tape is in play, use the MENU SELECTOR to adjust the volume.
■
A volume level display will appear on the LCD.
Levels may be adjusted from anywhere between 00 to 19 and you will not hear
any sound when the volume is set on 00.
■
If you close the LCD while playing, you will not hear sound from the speaker.
Notes
■
When the cable is connected to the AV jack, you cannot hear sound from the speaker and
cannot adjust the volume.
■
If a cable is connected to the AV jack, you can hear sound from the speaker when
AV IN/OUT MODE on MENU is set to AV IN. (VP-D301i/D303i/D303Di/D305i/D307i only)
■
You can hear sound from speaker by removing the connected cable from the AV jack.
Controlling Sound from the Speaker
0 : 2 3 : 4 7
5 5 min
VOL. [ 1 1 ]
1 2 : 0 0
1 0 . J A N . 2 0 0 4
<3-2>
2
3-1
00752F VP-D303(i)-UK (28~61) 5/28/04 9:55 AM Page 35