Samsung DCR-HC52 Camcorder User Manual


 
35
Using the Menu
2 Touch [ RET.] t .
To return to the normal playback mode,
touch (Play/Pause) twice (once from
frame playback).
b Notes
You will not hear the recorded sound. You may
see mosaic-like images of the previously played
picture.
Using the internal stereo microphone
(p. 69), you can add sound to a tape already
recorded in 12-bit mode (p. 42) without
erasing the original sound.
b Notes
You cannot record additional audio:
When the tape has been recorded in the 16-bit
mode (p. 42).
When the tape has been recorded in the LP
mode.
When your camcorder is connected via an
i.LINK cable.
When the tape has been recorded in 4CH MIC
mode on other camcorders.
On blank sections of the tape.
When the tape has been recorded in a TV
color system other than that of your
camcorder (p. 59).
When the write-protect tab of the cassette is
set to SAVE (p. 60).
On sections recorded in HDV format.
When you add sound, the picture will not be
output from the A/V Remote Connector. Check
the picture on the LCD screen or the viewfinder.
You can only record additional audio over a
tape recorded on your camcorder. The sound
may deteriorate when you dub audio on a tape
recorded on other camcorders (including other
DCR-HC52/HC54 camcorders).
Recording sound
Insert a recorded cassette into your
camcorder beforehand.
1 Slide the POWER switch repeatedly to turn
on the PLAY/EDIT lamp.
2 Touch (Play/Pause) to play back the
tape, then touch it again at the point where
you want to start recording the sound.
3 Touch t [PAGE3] t [A DUB
CTRL] t [AUDIO DUB].
4 Touch (Play).
Your camcorder starts audio recording via
the internal stereo microphone.
appears while recording the new sound
in stereo 2 (ST2) during the playback of the
tape.
5 Touch (Stop) when you want to stop
recording.
To dub on other scenes, repeat step
2 to
select scenes, then touch [AUDIO DUB].
To Touch
change the
playback
direction*
(frame)
play back
slowly**
[ySLOW]
To reverse direction:
(frame) t
[ySLOW]
play back 2
times faster
(double speed)
(double speed)
To reverse direction:
(frame) t
(double speed)
play back frame
by frame
(frame) during
playback pause.
To reverse direction:
(frame) during
frame playback.
* Horizontal lines may appear at the top,
bottom, or in the center of the screen. This
is not a malfunction.
**Pictures output from the DV Interface
(i.LINK) cannot be played back smoothly in
slow mode.
A DUB CTRL (Audio dubbing)
RET.
0:00:00:0060min
AUDIO
DUB
0:00:00:0060min
A DUB CTRL
X appears.
Continued ,