Filter
Top Products
MAINTENANCE
Your camcorder is a product of superior design and craftsmanship and should be treated with
care.
The suggestions below will help you fulfill any warranty obligations and allow you to enjoy this
product for many years.
t 'PSTBGFLFFQJOHPGUIFDBNDPSEFSUVSOPGGUIFDBNDPSEFS
- Remove the battery and AC power adaptor.
pages 16, 20
- Remove the memory card.
page 28
Cautions when storing
t Do not leave the camcorder in a place where the temperature is very high for a long
period of time:
The temperature inside a closed vehicle or trunk can become very high in a hot weather.
If you leave the camcorder in such a place, it could malfunction or the case could be
damaged. Do not expose the camcorder to a direct sunlight or place it near a heater.
t Do not store the camcorder in a place where the humidity is high or in a dusty place:
Dust entering the camcorder could cause a malfunction. If humidity is high, the lens could
become moldy, and the camcorder could become inoperative. It is recommended that you
put the camcorder in a box together with a small silica bag when storing it in a closet, etc.
t Do not store the camcorder in a place subject to strong magnetism or intense
vibration:
This could cause malfunctions.
t Detach the battery from the camcorder and store it in a cool place:
Leaving the battery attached or storing it at a high temperature could shorten its life.
Cleaning the camcorder
#FGPSFDMFBOJOHUVSOPGGUIFDBNDPSEFSBOESFNPWFUIFCBUUFSZBOE"$QPXFSBEBQUPS
t To clean the exterior
- Wipe gently with a soft dry cloth. Do not apply excessive force when cleaning. Gently rub
the surface.
- Do not use benzene or thinner to clean the camcorder. The exterior coating could peel
off or the case could deteriorate.
t To clean the LCD screen
Wipe very gently with a soft dry cloth. Be careful not to damage the screen.
t To clean the lens
Use an optional air blower to blow out dirt and other small objects. Do not wipe the lens with
cloth or your fingers.
If necessary, wipe gently with lens paper or tissue.
- Mold may form if the lens is left dirty.
- If the lens looks dim, turn off the camcorder and leave it off for about 1 hour.
maintenance & additional information
128