Filter
Top Products
ENGLISH
3737
Basic Recording
Searching a quickly for a desired scene (Setting the ZERO MEMORY) (SC-D364/D366 only)
✤ The ZERO MEMORY function works in both <Camera> and <Player> modes. ➥page 19
✤ You can mark a point on a tape that you want to return to following playback.
1. Set the [Power] switch to [CAMERA] or [PLAYER].
2. Set the [Mode] switch to [TAPE].
3. Press the [ZERO MEMORY] button on the remote control before the recording or during
playback at the point where you wish to return.
■
The time code is changed to a tape counter that is set to ZERO MEMORY with the
< 0:00:00> (ZERO MEMORY indicator).
■
If you want to cancel the ZERO MEMORY function, press the [ZERO MEMORY] button
again.
4. Finding the zero position.
■
When you have finished playback, fast forward or rewind the tape in stop mode.
The tape stops automatically when it reaches the zero position.
■
When you have finished recording, set the [Power] switch to [PLAYER] and press
the [
œœœœ
(REW)] button.
The tape stops automatically when it reaches the zero position.
5. The tape counter with the <>(ZERO MEMORY indicator) disappears from the display and the tape counter is
changed to the time code.
[ Notes ]
■
In the following situations, ZERO MEMORY mode may be canceled automatically:
- At the end of the section marked with the ZERO MEMORY function.
- When the tape is ejected.
- When you remove the Battery Pack or power supply.
■
The ZERO MEMORY may not function correctly where there is a break between recordings on the tape.
œ
P
L
A
Y
E
R
C
A
M
E
R
A
C
A
M
E
R
A
P
L
A
Y
E
R
1
00970A SCD363 USA~043 1/12/06 3:28 PM Page 37