Filter
Top Products
SETTINGS
Backlight compensation setting
Use an auto-iris lens and set the EI/BLC switch to the BLC-ON
position, to engage the backlight compensation function.
Use an auto-iris lens. Set the EI/BLC switch to BLC-ON switch to
the ON position.
If using a VIDEO type auto-iris lens
• The ALC volume on the lens should be turned all the way to Av (Average).
• If the backlight compensation function does not compensate properly for the conditions,
set using the LEVEL volume on the lens.
CAUTION:
The electronic iris function and the backlight compensation function cannot operate
simultaneously.
ON
OFF
ON
EI
BLC
LINE PHASE ADJUSTMENT
When using a camera switcher to connect 2 cameras or more to
one monitor, there may be a vertical roll of the images when
switched. In such a case, set as described below.
Switch the display on the monitor from camera 1 to camera 2.
Adjust the LINE PHASE volume on camera 2 until the vertical roll
of the image stops.
If more than two cameras are used, please repeat this procedure
for all the cameras.
CAUTION:
If the vertical roll cannot be corrected by setting the LINE PHASE
volume on camera 2, try setting the LINE PHASE volume on
camera 1. If it still cannot be corrected, please check that the
polarity of the power cords of all connected devices is correct.