Filter
Top Products
32
Devices for Satellite/GPS
33
FM Transmitter
■
Satellite LNB
[Satellite LNB]
IF OUT
Lo
IF Amp.LNA.
RF IN
MIX
LO
Frequency: 9 to 14GHz
■
GPS/XM Antenna Module
[GPS/XM Antenna Module]
Frequency: 1.57 to 2.3GHz
IF
OUT
Lo
IF Amp.MIX
LO
LNA.
ESD
RF IN
LNA.
ANTENNA
MODULE
NAVIGATION
SECTION
Ultrahigh-Frequency Transistors
Type No. Package
Absolute maximum ratings/Ta=25˚C
Electrical characteristics/Ta=25˚C
Block
V
CEO
[V]
I
C
[mA]
P
C
[mW]
f
T
typ
[GHz]
NF |S21e|
2
f
[GHz]
typ
[dB]
f
[GHz]
V
CE
[V]
I
C
[mA]
typ
[dB]
MCH4009
MCPH4
3.5 40 120 25 2 1.1 2 3 20 17 Lo/IF Amp.
MCH4011 3.5 100 350 24 2 1.1 2 3 50 14.5 Lo/IF Amp.
MCH4012 3.5 200 500 20 2 1.0 2 3 100 12 Lo/IF Amp.
MCH4020 8 150 500 16.5 2 1.2 1 5 50 17.5 Lo/IF Amp.
High-Frequency Schottky Barrier Diodes
Type No. Package
Absolute maximum ratings/Ta=25˚C Electrical characteristics/Ta=25˚C
Block
V
R
[V]
I
F
[mA]
P
[mW]
V
F
[mV]
Conversion Loss
[dB]
C
typ [pF]
●
SBX201C CP 2 50 - 280 8.6 0.25 Mixer
●
: New products
High-Frequency Transistors
Type No. Package
Absolute maximum ratings/Ta=25˚C
Electrical characteristics/Ta=25˚C
Block
V
CEO
[V]
I
C
[mA]
P
C
[mW]
f
T
typ
[GHz]
NF |S21e|
2
f
[GHz]
typ
[dB]
f
[GHz]
V
CE
[V]
I
C
[mA]
typ
[dB]
MCH4009
MCPH4
3.5 40 120 25 2 1.1 2 3 20 17 LNA
MCH4011 3.5 100 350 24 2 1.1 2 3 50 14.5 LNA
MCH4012 3.5 200 500 20 2 1.0 2 3 100 12 LNA
MCH4013 3.5 15 120 22.5 2 1.5 2 5 5 16 LNA
EC4H08C
ECSP1008
3.5 15 50 24 2 1.5 2 3 10 17 LNA
EC4H09C 3.5 40 120 26 2 1.3 2 3 20 16.5 LNA
■
FM Transmitter
Varactor Diode
Type No. Package
Absolute maximum
ratings/Ta=25˚C
Electrical characteristics/Ta=25˚C
V
R
[V]
C1 C2
∆Cm [%]
C1.0V/C4.0V
max
V
R
[V]
min max
V
R
[V]
min max
EC2C01C ECSP1008-2 15 1 18.5 21.5 4 3.5 4.5 5.0
SVC710 MCPH3 15 1 18.5 21.5 4 3.5 4.8 4.8
SVC707 SPA 15 1 18.58 21.26 4 3.61 4.73 3.0
V
DD
f_Ref
VCO
AS
CLK
DATA
ATT
PON
CONT.
LV2282VA
V_Reg
[Varactor Diode Use Example]
3.3V
V
CC
=+14.4V (From cigarette Lighter in a car)
RF OUT
3LN02M✕5
SANYO Semiconductor Co.,Ltd. assumes no responsibility for equipment failures that result from using
products at values that exceed, even momentarily, rated values (such as maximum ratings, operating
condition ranges, or other parameters) listed in products specifications of any and all SANYO Semiconductor
Co.,Ltd. products described or contained herein.
SANYO Semiconductor Co.,Ltd. strives to supply high-quality high-reliability products, however, any and all
semiconductor products fail or malfunction with some probability. It is possible that these probabilistic failures
or malfunction could give rise to accidents or events that could endanger human lives, trouble that could give
rise to smoke or fire, or accidents that could cause damage to other property. When designing equipment,
adopt safety measures so that these kinds of accidents or events cannot occur. Such measures include but
are not limited to protective circuits and error prevention circuits for safe design, redundant design, and
structural design.
Any and all information described or contained herein are subject to change without notice due to
product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification" for the
SANYO Semiconductor Co.,Ltd. product that you intend to use.
In the event that any or all SANYO Semiconductor Co.,Ltd. products described or contained herein are
controlled under any of applicable local export control laws and regulations, such products may require the
export license from the authorities concerned in accordance with the above law.
No part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying and recording, or any information storage or retrieval system, or
otherwise, without the prior written consent of SANYO Semiconductor Co.,Ltd.
Specifications of any and all SANYO Semiconductor Co.,Ltd. products described or contained herein stipulate
the performance, characteristics, and functions of the described products in the independent state, and are
not guarantees of the performance, characteristics, and functions of the described products as mounted in the
customer's products or equipment. To verify symptoms and states that cannot be evaluated in an
independent device, the customer should always evaluate and test devices mounted in the customer's
products or equipment.
Any and all SANYO Semiconductor Co.,Ltd. products described or contained herein are, with regard to
"standard application", intended for the use as general electronics equipment (home appliances, AV equipment,
communication device, office equipment, industrial equipment etc.). The products mentioned herein shall not
be intended for use for any "special application" (medical equipment whose purpose is to sustain life,
aerospace instrument, nuclear control device, burning appliances, transportation machine, traffic signal
system, safety equipment etc.) that shall require extremely high level of reliability and can directly threaten
human lives in case of failure or malfunction of the product or may cause harm to human bodies, nor shall they
grant any guarantee thereof. If you should intend to use our products for applications outside the standard
applications of our customer who is considering such use and/or outside the scope of our intended standard
applications, please consult with us prior to the intended use. If there is no consultation or inquiry before the
intended use, our customer shall be solely responsible for the use.
Upon using the technical information or products described herein, neither warranty nor license shall be
granted with regard to intellectual property rights or any other rights of SANYO Semiconductor Co.,Ltd. or any
third party. SANYO Semiconductor Co.,Ltd. shall not be liable for any claim or suits with regard to a third
party's intellectual property rights which has resulted from the use of the technical information and products
mentioned above.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed
for volume production.