Filter
Top Products
EN-31
Saturation
This sets the saturation of the image that will be captured.
* High / Standard / Low
Metering
This sets the metering method for calculating the exposure.
Capture Md.
This sets the recording method at the time of capturing images.
Quick Shot
If this function is set to “On”, the camera takes a quick shot without focusing.
* On / Off
Digi. Zoom
This sets whether or not to use digital zoom at the time of photography.
* On / Off
Date Print
The date of recording can be printed directly on the still images. This function must be
activated before the image is captured.
* On / Off
Setup
Refer to the section in this manual titled “Setup Menu” for further details.
* Center: Averages the light metered from the entire frame, but gives greater
weight to the subject matter at the center.
* Spot: A very small portion of the center of the screen is measured to calculate
the correct exposure.
* Average: The exposure is measured all of the image area.
* Single: Captures one image at a time.
* Continuous: Permits continuous capture of up to 3 images.
* AEB: Permits 3 consecutive images in the order of standard exposure,
underexposure and overexposure compensation.
* Burst: Permits continuous photography while pressing and holding the shutter
button. As long as you hold the shutter button pressed, images are
captured until the memory capacity is exhausted.
* Cont. flash: Permits continuous capture of up to 3 images with flash.
* Pre-shot: Select a background by 1st shot, the image shown on display will be
transparent, then take the 2nd shot on the basis of 1st image. Image of
1st shot is only a guiding tool, it won't be saved on SD card. Normally this
function is used when taking a portrait picture and the background is
selected by the model instead of the photographer.
* Coupl.shot: Uses separate areas to combine two shots. You can include yourself in
the shot.