Filter
Top Products
EN-34
Sharpness
This sets the sharpness of the image that will be captured.
* Hard / Standard / Soft
Color
This sets the color of the image that will be captured.
* Standard / Vivid / Sepia / B&W / Blue / Red / Green / Yellow / Purple
Saturation
This sets the saturation of the image that will be captured.
* High / Standard / Low
Metering
This sets the metering method for calculating the exposure.
Capture Md.
This sets the recording method at the time of capturing images.
Quick Shot
If this function is set to “On”, the camera takes a quick shot without focusing.
* On / Off
* Center: Averages the light metered from the entire frame, but gives greater
weight to the subject matter at the center.
* Spot: A very small portion of the center of the screen is measured to
calculate the correct exposure.
* Average: The exposure is measured all of the image area.
* Single: Captures one image at a time.
* Continuous: Permits continuous capture of up to 3 images.
* AEB: Permits 3 consecutive images in the order of standard exposure,
underexposure and overexposure compensation.
* Album Shot: Creates an album-like layout to combine 3 shots into a single image.
* Burst: Permits continuous photography while pressing and holding the
shutter button. As long as you hold the shutter button pressed,
images are captured until the memory capacity is exhausted.
* Cont. flash: Permits continuous capture of up to 3 images with flash.
* Pre-shot: Select a background by 1st shot, the image shown on display will be
transparent, then take the 2nd shot on the basis of 1st image. Image
of 1st shot is only a guiding tool, it won't be saved on SD card.
Normally this function is used when taking a portrait picture and the
background is selected by the model instead of the photographer.
* Coupl.shot: Uses separate areas to combine two shots. You can include yourself
in the shot.