Sanyo LNS-W32 Camera Lens User Manual


 
Following checks and confirmations should be taken for safety.
Check the following things by the time of the cabinet assembly after the lens
replacement.
1. Check the lens is securely fixed.
2. Check no parts is missing, or no mounting part is loose.
LCD PROJECTOR LENS
MODEL LNS-W32
LENS REPLACEMENT PROCEDURE
NOTES ON LENS REPLACEMENT
The ZOOM, FOCUS and LENS SHIFT adjustment on the Top Control or the
Remote Control cannot be operated with this Lens.
Lens replacement should be performed by the qualified service personnel.
It should be followed by this procedure precisely.
Before attempt to replace the lens, confirm the model number (both the LCD
projector and the lens) and use the proper lens.
The lens cover is on the lens for protection. Be sure to remove the lens cover
before installation.
When installing or removing the lens, be careful not to stain, scratch or
damage the lens.
Following parts are contained in the packing.
1AA6P1P3217A- (ICZAA-A)
PARTS LIST
LENS
LIGHT-BLOCK SHEET BASE
DRIVER (3 mm, Green)
DRIVER (4 mm, Yellow)
LIGHT-BLOCK SHEET
SCREW
1 piece
1 piece (Part No. 610 310 8001)
1 piece (Part No. 610 287 7328)
1 piece (Part No. 610 275 6029)
1 piece Type PC1 (Part No. 610 310 7967)
1 piece Type PD1 (Part No. 610 294 3047)
2 pieces (Spare parts)
Some parts are not used for installation or replacement. Keep these parts and
drivers included in the lens for later use.
NOTE; Lens installation is different in cabinet design and lens attachment method
(Type A, B and C). Before installation the lens, check cabinet design and
proper installation should be made.