Filter
Top Products
-4-
Fig-6
Fig-7
DRIVER
IN THE LENS
LENS MOUNTING
BRACKET
4
MOUNT THE LENS (See Figure-5 and 6)
5
MOUNT THE LIGHT-BLOCK SHEET AND
FRONT PANEL (See Figure-7)
Remove protective caps (front and back) on the
lens.
Mount the lens on lens mounting bracket with 4
screws.
Use the driver (4 mm, Yellow) included with the
lens to fasten the screws.
1.
2.
Mount the light-block sheet to the lens as shown in
the Figure-7. Use the sheet included with the lens.
Make sure the part no. and mark (TOP and BACK)
on Light-Block Sheet and set them properly.
Mount the Front Panel (Separately ordered) with
the screws.
1.
2.
3.
FRONT PANEL
(OPTIONAL PART)
LIGHT-BLOCK SHEET
Type PD1
(Part No. 610 294 3047)
CONFIRM THE FOCUS
Project picture on screen and confirm the focus. If
proper focus is not observed at screen, adjust focus
following Focus Adjustment on this page.
Light block sheet base is not used.
FOCUS ADJUSTMENT
Set up the projector and project image on the screen.
1. Loosen the Focus Lock Screw on the lens.
2. Rotate the lens to obtain proper focus on center
area of the screen.
3. Tighten the Focus Lock Screw.
When proper focus is not observed at outer area of
the screen, proceed to following adjustments.
4. Loosen the Focus Lock Ring of the lens. (Turn the
Lock Ring to counter-clockwise.)
5. Rotate the lens to obtain proper focus on outer
area of the screen.
6. Lock the Focus Lock Ring securely. (Turn the Lock
Ring to clockwise.)
If proper focus is not observed entire screen, repeat
above adjustment 1~ 6.
Focus Lock Screw
Focus Lock Ring