Filter
Top Products
E-17
Pop up the camera's built-in
flash. Align the camera tray
with the camera base inside the
front case, and slide the camera
forward into the front case
Make sure to pop up the built-in flash
of the camera before mounting the
camera in the housing. Once the
camera has been mounted, the flash
button of the camera cannot be used,
and the camera's built-in flash cannot
be popped up.
Make sure the camera tray is inserted
all the way into the camera base until
it stops.
Make sure that the camera tray is
properly placed and the knob is
locked.
Mounting the Camera in the Housing
6
Pull the power switch and
focus/zoom dial out
Make sure that the O-ring is properly fitted in the O-ring groove before
setting of the rear case.
8
Place the rear case on the front
case, and close the buckles
See:
“Opening and Closing the Housing” (P. E-13)
Align the lever of the housing's
power switch and the camera's
power switch
7
After the camera is mounted in the housing, make sure to check that all of
the housing's control parts work properly and the camera functions correctly.
CAUTION
5
Power switch
Lever