Filter
Top Products
SECO-LARM Mid-Size Vandal Dome Cameras
SECO-LARM U.S.A., Inc. 3 SECO-LARM U.S.A., Inc. 33 3
1. Please read this manual carefully and keep it for future
reference.
2. Use the camera within given temperature and electricity
limits.
3. Do not point the camera at the sun. Heat could damage
the camera, even when not in use.
4. Do not mount the camera in areas exposed to radiation,
strong magnetic fields, or strong electrical signals*
5. Do not drop the camera or subject it to strong
vibrations.
Note: Many video monitors produce strong
electromagnetic fields close to the display CRT,
especially when the monitor is turned on or during
de-gaussing, which occurs automatically with many
monitors when turned on.
Before Starting:
1. Run hidden cables from the video source and 12VDC
power supply to the camera. Do not cut the DC jack or
the female BNC connector as this will void the
warranty. If needed, use the included SECO-LARM
DC plug with terminal block.
2. Test to make sure the voltage is correct.
Use only 12VDC.
3. Undo the 3 set screws on the side of the dome cover
using the included allen wrench and remove the dome
from the base.
4. Hold the camera against the wall, ceiling, or other
mounting surface while watching the monitor to find the
best mounting location. Mark that location with a pencil.
5. If the installation involves surface wiring, use the wiring
notch located on the side of the mounting base
to run wires.
Installation:
6. Mount the mounting base to the wall using the 3
included mounting screws. If necessary, use the
included screw anchors.
7. Adjust the camera angle as shown on page 2,
Adjusting the Camera Angle.
8. Test the video signal.
9. Models ending in NV WQ and PVWQ only: Adjust
the zoom and focus by hand or with a small
screwdriver to loosen the knob, and then sliding the
knob left or right. IMPORTANT: Do not use power
tools. Lens damage may result.
10. Reattach the dome to the camera.
11. Use the included allen wrench to tighten the set
screws, securing the dome to the base.
12. Do a final test of the video camera and monitor.
Overview:
Important:
Do not cut the DC jack or
the female BNC connector
as this will void the
warranty.
Dome cover
DC jack
Mounting screw
Set screw
Female BNC connector
Camera
Mounting base
Wiring notch
DC plug with
terminal block
Models ending in
NVWQ or PVWQ only.
Zoom
Focus