Filter
Top Products
SECO-LARM Large Vandal Dome Cameras
SECO-LARM U.S.A., Inc. 3
Before Starting:
Installation:
Overview:
1. Please read this manual carefully and keep it for
future reference.
2. Use the camera within given temperature and
electrical limits.
3. Do not aim the LEDs directly at the eyes when the LEDs
are on.
4. Do not point the camera at the sun. Heat could damage
the camera, even when not in use.
5. Do not mount the camera in areas exposed to radiation,
strong magnetic fields, or strong electrical signals
1
.
6. Do not open or disassemble the camera. There are no
field-serviceable parts inside.
7. Do not drop the camera or subject it to strong
vibrations.
1
Note: Many video monitors produce strong
electromagnetic fields close to the display CRT,
especially when the monitor is turned on or during
de-Gaussing, which occurs automatically with
many monitors when turning on.
1. Run hidden cables from the video source and 12VDC
power supply and connect to the camera. Do not cut
the DC jack or the female BNC connector as this will
void the warranty. If needed, use the included
SECO-LARM DC plug with terminal block.
2. Test to make sure the voltage from the power supply is
correct. Use only 12VDC.
3. Undo the 4 set screws on the side of the dome cover
using the included allen wrench and remove the dome
from the base.
4. If mounting outdoors, apply the rubber seal to the base
as shown on page 2, Applying the Rubber Seal.
5. Hold the camera against the wall, ceiling, or other
mounting surface while watching the monitor to find the
best mounting location. Mark that location with a pencil.
If the installation involves surface wiring, remove the
conduit cap using a screwdriver and run wires
through the hole.
6. Mount the mounting base to the wall using the 4
included mounting screws. If necessary, use the
included screw anchors.
7. Adjust the camera angle as shown above.
8. Test the video signal.
9. To adjust zoom and focus, loosen the lock knobs by
hand or with a screwdriver. Slide left or right to
adjust. Do not use power tools. Lens damage
may result.
10. Reattach the dome to the camera using the included
allen wrench to tighten the set screws.
11. Do a final test of the video camera and monitor.
Important:
Do not cut the DC jack or the female BNC
connector as this will void the warranty.
Zoom
DC plug with
terminal block
Focus
Conduit cap
Female BNC
connector
DC jack
Set screws
Mounting screws
Adjusting the
Camera Angle
Move the camera along
its 3 axes to adjust the
pan, tilt, or rotation.