Filter
Top Products
SECO-LARM Indoor IR Dome Cameras
SECO-LARM U.S.A., Inc. 3 SECO-LARM U.S.A., Inc. 33 3
1. Run hidden cables from the video source and 12VDC
power supply to the camera. Connect to the DC jack
and female BNC connectors. Do not cut the DC jack
or the female BNC connector as this will void the
warranty. If needed, use the included SECO-LARM
DC plug with terminal block.
2. Test to make sure the voltage is correct.
Use only 12VDC.
3. Hold the camera against the wall, ceiling, or other
mounting surface while watching the monitor to find the
best mounting location. Mark that location
with a pencil.
4. Remove the dome from the camera by twisting it
counterclockwise.
5. Remove the mounting base by releasing the latch
indicated by white arrow on the inner rim of the
camera.
6. If flush mounting, remove the punch-out in the base
and run the wires through the center of the base.
Installation:
7. Mount the mounting base by using the three included
mounting screws to secure it to the wall. If the wall is
made of drywall, brick, or similar material, it may be
necessary to also use the three included screw anchors.
8. Secure the camera by lining it up with the base and turning
the camera clockwise. To line up, make sure the gap in the
mounting base is aligned with the wiring notch. The
camera will click when locked into place.
9. Adjust camera angle as shown on page 2, Adjusting the
Camera Angle.
10. Test the video signal.
11. Varifocal models only: Adjust the zoom and focus by
hand or with a small screwdriver to loosen the knob, and
then sliding the knob left or right. IMPORTANT: Do not
use power tools. Lens damage may result.
12. Reattach the dome to the camera by giving the dome a
slight twist. The dome will click when locked into place.
13. Do a final test of the video camera and monitor.
1. Please read this manual carefully and keep it for
future reference.
2. Use the camera within given temperature and
electrical limits.
3. Do not aim the LED light directly at the eyes when the
LEDs are on.
4. Do not point the camera at the sun. Heat could damage
the camera, even when not in use.
5. Do not mount the camera in areas exposed to radiation,
strong magnetic fields, or strong electrical signals.*
6. Do not open or disassemble the camera. There are no
user-serviceable parts inside.
7. Do not drop the camera or subject it to strong vibrations.
Note: Many video monitors produce strong
electromagnetic fields close to the display CRT, especially
when the monitor is turned on or during de-gaussing,
which occurs automatically with many monitors when the
monitor is turned on.
Before Starting:
Overview:
Important:
Do not cut the DC jack or the female BNC
connector as this will void the warranty.
Camera cover
Dome cover
Camera
Mounting
screws
Mounting base
Latch
Arrow
DC jack
Female BNC
connector
DC plug with
terminal block
Focus
knob
Zoom
knob
Varifocal models only
To remove the
mounting base,
release the latch.
Punch-out