Filter
Top Products
To rotate the camera left or right, loosen the Panning lock knob. When
you want to lock in at a certain position, tighten the Knob.
For vertical position shots with your still camera, Ioosen the Vertical tilt
lock knob, and tilt the Camera platform to the desired position.
Then lock the vertical tilt lock knob.
Loosen the Center column locking collar, and turn the Elevation crank
handle to raise or lower the Center column.
Always be certain to tighten the Locking collar before taking your hands
off the Crank handle to prevent accidental falls.
The “Center lock” mechanism featured in this model prevents unwanted
camera movements which often occurs when tightening the center column.
Holding two legs, one in each hand, tilt the tripod on its third leg.
Pull the two legs you are holding outward, and all three legs will open at
once. Open until the Center column ring is seated at the very bottom of
the Center column.
To close the legs, be sure to first raise the Center column ring up slightly,
and then push the legs close.
Flip up the Leg lock lever to extend or shorten any of the individual leg
sections to the desired length, and press the leg lock lever flush against
the leg to lock.
For greater stableness, use the thicker leg columns first.
Use the Center column tension adjustment tube located around the
Center column if you wish to adjust the tension of the center column
movement.
Rotate the tube counterclockwise to increase tension.
For less tension, rotate clockwise.
How to use the 3 Way pan head
How to open and close the tripod legs
Slik’s 3 way Pan head allows your still, or video camera, three indepen-
dent movements.
Turn the Pan handle barrel counterclockwise until you feel it loosen, and
you can tilt the camera up and down. When you have the angle you want,
tighten the Handle in a clockwise direction until it locks in.
Panning lock knob
Pan handle
Vertical tilt lock knob
Extending the tripod legs
Elevating the center column Adjusting elevation tension
Care of the Tripod
・DO NOT apply any grease or oil to this product.
・Clean with a mild detergent and a soft cloth only.
・DO NOT use close to flame. Avoid extreme heat.
Slik Corporation reserves the right to make changes in design and/or improvements on the products without any obligation and advanced notice.
SLIK CORPORATION
853 Kayama, Hidaka City, Saitama 350-1231 Japan Phone 81-42-989-2141, Fax. 81-42-985-0210 ©2006
OIL
THINNER