Snapper ERP217018BV Camcorder User Manual


 
HANDLES & CONTROLS
Footnotes:
TP 400-5047-1-WB-N
Manual No. 700613921" STEEL DECK
SERIES 18
5
Part No Descri
p
tionItem Qt
y
Note
1 7074411 1 HANDLE, Upper All
2 7074156 1 HANDLE, Middle All
3 7033985 1 HANDLE, Lower LH (Adjustable) All
4 7033986 1 HANDLE, Lower RH (Adjustable) All
5 7074418 1 BAIL, OPC Control All
6 7034872 1 CLIP, Zone Control All
7 7034608 1 *CABLE, Zone Control (52-63/64” Long)
7 7078078 1 CABLE, Zone Control (50-31/64” Long) P217018BVE & RP217018BVE
7 7074141 1 CABLE, Zone Control (56-5/16” Long) P216018KWV & RP216018KWV
8 7074473 1 HANDLE, Clutch Self-Propelled Models
9 7028407 1 GRIP, International Symbol Self-Propelled Models
10 7034604 1 CABLE, Clutch Control (41-1/4” Long) Self-Propelled Models
11 7012121 1 COVER, Vinyl Self-Propelled Models
12 7012122 1 SPRING, Clutch- 21S Self-Propelled Models
13 7074003 1 BRACKET, Shift All
14 7024641 2 TIE, Wire, 1.29 long, black Self-Propelled Models
15 7073822 1 BRACKET, Bell Crank Self-Propelled Models
16 7013849 1 SPACER, .33 x .63 x .156 Self-Propelled Models
17 7073913 1 BELL CRANK Self-Propelled Models
18 7073826 1 CONTROL PANEL (w/o Ground Drive Slot) 216518B
18 7074140 1 **CONTROL PANEL (w/o Electrical Switch Hole)
18 7074469 1 CONTROL PANEL (w/Electrical Switch Hole) P217018BVE & RP217018BVE
19 7091200 4 SCREW, 1/4-20 x 1/2” Pan Head Self-Tap (Torx) All
20 7091130 1 WASHER, .33 x .88 x .09 Flat Self-Propelled Models
21 7091904 1 SCREW, 5/16-18 x 7/8” Hex Head Cap, GR 5 Self-Propelled Models
22 7090895 1 TEENUT, 5/16-18 Self-Propelled Models
23 7012114 1 BUSHING, Differential, .328 x .625 x .41 Self-Propelled Models
24 7090595 3 BOLT, 5/16-18 x 3/4” Hex Flange Lock GR 5 All
25 7091601 2 NUT, 5/16-18 Hex Flange Lock, GR 5 was 7090585 (All)
26 7091575 1 NUT, 5/16-18 Hex Center Lock was 7091067 (S-P Models)
27 7074113 1 LEVER, Shift Self-Propelled Models
28 7091606 1 NUT, 5/16-24 Hex Center Lock GR 5 was 7091074 (All)
29 7023813 1 CLIP, Wiring Harness All
30 7091740 4 SCREW, 5/16-18 x 1-7/8” Curved Head GR 2 was 7091189 (All)
31 7035744 4 KNOB, 5/16-18 Wing (Black) All
32 7079577 2 SCREW, 1/4-20 x 1-1/2 Hex Head Cap GR 5 All
33 7090053 3 WASHER, 1/4” Internal Tooth Lock was (All)
Note* used on 216518B, P216518B, P217018BV, RP217018BV, EP217018BV & ERP217018BV
Note** used on P217018BV, P216518B, P216018KWV, RP217018BV, RP216018KWV, EP217018BV & ERP217018BV
Note* See also Throttle Control Page
ref Decal Page