Filter
Top Products
65
Additional information Дополнительная информация
The image on the viewfinder
screen is not clear.
A vertical band appears when a
subject such as lights or a candle
flame is shot against a dark
background.
The picture is “noisy”.
A vertical band appears when
shooting a very bright subject.
An unknown picture is displayed
in the viewfinder.
The picture on a TV screen is
unclear and background noise
occurs. (CCD-TR740E only)
Symptom Cause and/or Corrective Actions
• Reset the date and time. (p. 51)
• STEADY SHOT is set to OFF.
m Set STEADY SHOT to ON. (p. 43)
• The SteadyShot function does not work when the wide mode is
set to 16:9FULL.
• FOCUS is set to MANUAL.
m Set it to AUTO (p. 39)
• Shooting conditions are not suitable for autofocus.
m Set FOCUS to MANUAL to focus manually. (p. 39)
• START/STOP MODE switch is set to or 5 SEC.
m Set it to . (p. 31)
• There are unwanted blanks before or after the title.
m Delete them then select ↵.
• The START/STOP MODE switch is set to 5 SEC or .
m Set it to . (p. 31)
• The stereo tapes is played back with HiFi SOUND set to 1 or 2
in the menu system.
m Set to STEREO in the menu system. (p. 29)
Picture
Symptom Cause and/or Corrective Actions
• The viewfinder lens is not adjusted.
m Adjust the viewfinder lens. (p. 14)
• The contrast between the subject and background is
too high. The camcorder is not malfunctioning.
m Change locations.
• The video heads may be dirty.
m Clean the heads using the Sony V8-25CLH cleaning cassette.
(p. 58)
• The camcorder is not malfunctioning.
• If 10 minutes elapsed after you set the POWER switch to
CAMERA without inserting a cassette, the camcorder
automatically starts the demonstration.
m Insert the cassette, and the demonstration stops. You can
make the demonstration not appear. (p. 29)
• The camcorder and the receiver are not facing each other.
m Adjust the position and angle of both units.
• Another infrared emitting appliance is operating.
m Stop operating it.
Trouble check
The SteadyShot function does not
activate. (CCD-TR720E/TR740E
only)
The date or time indicator
disappears.
The autofocusing function does
not work.
Recording stops in a few seconds.
The title display position shifts.
The fader function does not work.
No sound or only a low sound is
heard when playing back a tape
(CCD-TR506E/TR720E/TR740E
only) .
Continued to the next page