Filter
Top Products
7
Getting started
CCD-TRV12/TRV22/TRV33/TRV112/TRV212 3-859-057-15.E
1
2
NP-78
175 (95)
220 (120)
180
NP-98/98D
220 (110)
300 (160)
220
NP-60D
95 (50)
125 (70)
95
NP-C65
100 (50)
150 (80)
100
NP-80/80D
190 (100)
250 (135)
190
NP-68/66H
135 (70)
170 (95)
135
NP-33(supplied)
65 (30)
85 (40)
65
LCD open
2)
LCD close
1)
Approximate continuous recording time indoors is indicated outside of parentheses.
Approximate minutes when recording while you repeat recording start/stop,
zooming and turning the power on/off are indicated in parentheses. The actual
battery life may be shorter.
2)
Approximate minutes when using the LCD screen. When using both the viewfinder
and LCD screen, the battery life is shorter.
3)
Approximate continuous playback time indoors.
If the LCD BACK LIGHT switch is set to BRIGHT while the LCD screen is open, the
battery life is approximately 10% shorter.
To remove the battery pack
Slide the battery pack in the direction of the arrow.
Installing the battery pack
(1) Insert the top of the battery pack into the top of the battery mounting surface.
(2) Push the battery pack so that it attaches firmly. Make sure that you hear clicks
twice.
Notes on charging the battery pack
• The POWER lamp will remain lit for a while even if the battery pack is removed and
the power cord is unplugged after charging the battery pack. This is normal.
• If the POWER lamp does not light, set the selector to VTR (DC OUT) and disconnect
the power cord. After about one minute, reconnect the power cord and set the selector
to CHARGE again.
• You cannot operate the camcorder using the AC power adaptor while charging the
battery pack.
CCD-TRV22/TRV33/TRV212
While
recording
1)
While playing back on
LCD
3)
Battery pack