Filter
Top Products
19
Advanced operations
CCD-TR3400 3-859-084-22 (1)
Using alternative power sources
Advanced operations
You can choose any of the following power sources for your camcorder: battery pack,
alkaline battery, house current and 12/24 V car battery. Choose the appropriate power
source depending on where you want to use your camcorder.
Place
Indoors
Outdoors
In the car
Note on power sources
Disconnecting the power source or removing the battery pack during recording or
playback may damage the inserted tape. If this happens, restore the power supply again
immediately.
Using the house current
To use the supplied AC power adaptor:
(1) Connect the AC power cord to a wall outlet.
(2) Slide the connecting plate down into the guides at the rear of the camcorder
until it clicks.
Notes on the VTR/CAMERA lamp
• The VTR/CAMERA lamp will remain lit for a while even if the unit is unplugged
after use. This is normal.
• If the VTR/CAMERA lamp does not light, disconnect the power cord. After about 1
minute, reconnect the power cord.
To remove the connecting plate
The connecting plate is removed in the same way as the battery pack.
WARNING
The power cord must only be changed at a qualified service shop.
PRECAUTION
The set is not disconnected from the AC power source (house current) as long as it is
connected to the house current, even if the set itself has been turned off.
Accessory to be used
Supplied AC power adaptor
Battery pack NP-F530 (supplied), NP-F730,
NP-F930
Battery case (supplied)
Sony car battery changer DC-V515A
Power source
House current
Battery pack
Size AA (LR6) Sony
Alkaline battery
12 V or 24 V car battery
12