Filter
Top Products
10
You can charge the battery after attaching the
“InfoLITHIUM” battery pack (P series) to
your camcorder.
1 Slide the battery pack in the
direction of the arrow until it clicks.
2 Slide the POWER switch in the
direction of the arrow to set it to
OFF (CHG) (The default setting).
3 Connect the AC Adaptor to the DC
IN jack on the Handycam Station.
Be sure that the v mark on the DC
plug is facing up.
4 Connect the power cord to the AC
Adaptor and the wall outlet.
5 Set the camcorder onto the
Handycam Station securely.
The CHG (charge) lamp lights up and
charging starts. The CHG (charge) lamp
turns off when the battery pack is fully
charged. Remove the camcorder from the
Handycam Station.
To remove the battery pack
Slide the POWER switch to OFF (CHG).
Slide the BATT (battery) release lever and
remove the battery pack.
• When you remove the battery pack, make sure
that none of the respective lamps of the POWER
switch (p.12) is on.
Step 2: Charging the battery pack
1
2
3
4
5
5
POWER
switch
CHG
lamp
DC IN jack
DC plug
AC Adaptor
Power cord
To the
wall outlet
Battery pack
BATT (battery)
release lever